Free Shipping over $150 | 20% off sitewide with code: GOTTAHAVEIT

STEPS TO LASH SUCCESS

READY TO LASH FORWARD INTO A NEW LIFE? FABULOUS, BECAUSE YOU'RE ABOUT TO EMBARK ON THE MOST REMARKABLE JOURNEY.

As with anything worth doing in life, Lashify takes a little bit of practice. So, be patient and kind with yourself while learning the system, and don't get discouraged if you don’t perfect Lashify on your first try. We're here to walk you through it all. Let's get started.

Begin with a completely clean canvas: no mascara, concealer, skincare products, or makeup of any kind around the eye area. Use Pre-Cleanse to ensure your lashes and lids are free of any oils. Apply using a lint-free cotton pad or disposable mascara spoolie.

Apply a very light coat of Whisper Light™ in black through your natural lashes and wait 30 seconds to one minute. Repeat by dabbing Whisper Light in black to the base of your natural lashes, concentrated above the root and wait 30 seconds to one minute. Proceed by adding dots of Whisper Light in clear about 1mm-2mm above the water line. This will serve as a marker for where to apply the Gossamer® lash.

Gently remove Gossamer® lashes from the cartridge using your finger tips, getting as close to the base of the lash as possible. If removing Gossamers with the Fuse Control™ Wand, gently do so in a soft and smooth motion with the Wandoms™ applied to the tips of the wand. This creates a cushiony grip that protects the delicate Gossamer lash while retrieving from cartridge. Once the bond has dried clear and become tacky, use the Fuse Control™ Wand to place the Gossamer® on the underside of your upper lashes. Never place Gossamers on the waterline, so be sure to leave at least 2mm of space between the waterline and the Gossamer, allowing you to see the root of your natural lashes.

Using the curved end of the Fuse Control™ Wand, follow the curvature of your eyelid and press down to "fuse" the Gossamer® lashes to your natural ones. In essence: clamp down to fuse, and release. Apply the Wandoms to the tips of your wand for a non-stick, cushiony and tack-free fuse.

Once your lash look is complete, finish with an application of Glass for longevity. Apply to the underside of the lashes, focusing on the root, to seal and remove any stickiness.

To remove Gossamers®, shake Melt Away to activate the dual-phase formula. Fully saturate a lint-free cotton pad and gently press down, holding the pad over your eyelids and lashes for a few seconds before sliding off Gossamer® lashes. You can also use a disposable mascara spoolie to brush Melt Away through the lashes.

1. PREP

Pre-Cleanse

$31.00

Pre-Cleanse - 200ml

$48.00

2. BOND

Whisper Light™ Dual Sided Bond with Micro Mascara Tip

$22.00

Whisper Light™ Dual Sided Bond with Mixed Tips

$28.00

3. GOSSAMER TIME

Amplify Gossamer® Lashes

$20.00

Bold Gossamer® Lashes

$20.00

4. FUSE

Fuse Control™ Wand - Sapphire

$65.00

Fuse Control™ Wand - Silver

$65.00

5. SEAL

Glass

$21.00

6. REMOVE

Melt Away

$21.00

1. PREP

Begin with a completely clean canvas: no mascara, concealer, skincare products, or makeup of any kind around the eye area. Use Pre-Cleanse to ensure your lashes and lids are free of any oils. Apply using a lint-free cotton pad or disposable mascara spoolie.

SHOP THE STEP

Pre-Cleanse

$31.00

Pre-Cleanse - 200ml

$48.00

2. BOND

Apply a very light coat of Whisper Light™ in black through your natural lashes and wait 30 seconds to one minute. Repeat by dabbing Whisper Light in black to the base of your natural lashes, concentrated above the root and wait 30 seconds to one minute. Proceed by adding dots of Whisper Light in clear about 1mm-2mm above the water line. This will serve as a marker for where to apply the Gossamer® lash.

SHOP THE STEP

Whisper Light™ Dual Sided Bond with Micro Mascara Tip

$22.00

Whisper Light™ Dual Sided Bond with Mixed Tips

$28.00

3. GOSSAMER TIME

Gently remove Gossamer® lashes from the cartridge using your finger tips, getting as close to the base of the lash as possible. If removing Gossamers with the Fuse Control™ Wand, gently do so in a soft and smooth motion with the Wandoms™ applied to the tips of the wand. This creates a cushiony grip that protects the delicate Gossamer lash while retrieving from cartridge. Once the bond has dried clear and become tacky, use the Fuse Control™ Wand to place the Gossamer® on the underside of your upper lashes. Never place Gossamers on the waterline, so be sure to leave at least 2mm of space between the waterline and the Gossamer, allowing you to see the root of your natural lashes.

SHOP THE STEP

Amplify Gossamer® Lashes

$20.00

Bold Gossamer® Lashes

$20.00

4. FUSE

Using the curved end of the Fuse Control™ Wand, follow the curvature of your eyelid and press down to "fuse" the Gossamer® lashes to your natural ones. In essence: clamp down to fuse, and release. Apply the Wandoms to the tips of your wand for a non-stick, cushiony and tack-free fuse.

SHOP THE STEP

Fuse Control™ Wand - Sapphire

$65.00

Fuse Control™ Wand - Silver

$65.00

5. SEAL

Once your lash look is complete, finish with an application of Glass for longevity. Apply to the underside of the lashes, focusing on the root, to seal and remove any stickiness.

SHOP THE STEP

Glass

$21.00

6. REMOVE

To remove Gossamers®, shake Melt Away to activate the dual-phase formula. Fully saturate a lint-free cotton pad and gently press down, holding the pad over your eyelids and lashes for a few seconds before sliding off Gossamer® lashes. You can also use a disposable mascara spoolie to brush Melt Away through the lashes.

SHOP THE STEP

Melt Away

$21.00

TROUBLESHOOTING

Help! A Gossamer is loose in the clamshell

The clamshell holds the Gossamer® lashes in place should any escape the cartridge during shipping. The cartridge needs to be tight enough to hold the lashes in place, but not too tight that you would damage a Gossamer trying to remove it. So, if you find a loose one, have no fear: a loose Gossamer is just as good as one that didn't escape.

Help! A Gossamer is stuck in the cartridge and won't come out

Once in a while it might feel like a Gossamer® is stuck inside the cartridge. If so, do not force it out. Instead, use the tip of a tweezer or sharp edge to pop open the black lid of the cartridge and safely remove Gossamers.

Help! How do I shower while wearing Lashify?

Take a shower as you normally would, but keep your face out of hot water. If you feel any Gossamers® become a little loose, don't worry! Just don't touch your lashes until they are dry. If needed, fuse once dry.

Help! How do I wash my face while wearing Lashify?

Saturate the Black Magic Cleansing Puff with water and wipe away all make-up and impurities without damaging your lashes. No cleanser needed. If you don't have the Black Magic Cleansing Puff, simply avoid any oil based cleanser near your eyes, and don't splash your eyes with hot water.

Help! My lashes feel a little sticky

Oh no! Sounds like you've over-bonded, AKA used too much bond. In the future, remember that a little bond goes a long way! As for the stickiness, don't worry! Glass is included in the Control Kit to help remove any stickiness. Just apply a coat and you're good to go!

Help! My lashes don’t last / slide off

Follow the ABC's to adhesion and longevity.
Prep: always make sure you're working with a clean canvas prior to Gossamer application. Oil-free lids and lashes ensure adhesion.
Bonding: over-bonding is the enemy. Too much bond will cause the Gossamers to slide right off, preventing adhesion.
Placement: if the Gossamer is placed too close to the waterline, not only will it feel uncomfortable, but it also won't adhere. Make sure you can see the root of your natural lash when applying.

Help! How do I remove eye makeup without disturbing my lashes?

If you are wearing serious, sparkly shadows, lift off with a piece of scotch tape, followed by a cotton pad with makeup remover or Melt Away. Follow up with Pre-Cleanse to ensure there is no oil residue, and finish with a q-tip dipped in Pre-Cleanse near the lash line to keep lashes looking fresh.

Help! How do I remove face makeup without disturbing my lashes?

Saturate the Black Magic Cleansing Puff with water and wipe away all make-up and impurities without damaging your lashes. No cleanser needed.

Help! How do I remove my Gossamer lashes?

When it's time, remove using Melt Away or any other dual-phase remover. When using Melt Away, press a fully saturated cotton pad over your eyelids for a few seconds before gently wiping away Gossamers® and any eye makeup.

Log in or sign up to start earning points.

This purchase earns Lash Cash points

BACK TO TOP